Sand casting of prototypes

In our department for prototypes and low-volume production there is a complete hand moulding foundry for casting weights up to just over 50 kg in cold-hardening sand or 3D-printed sand. All alloys used at Fundo can also be used in sand casting. However, the strength properties will be slightly lower in sand casting compared to permanent mould casting due to the lower solidification rate.

Kontakta oss för mer information

Genom att skicka in formuläret godkänner du att Fundo sparar information om dig. Läs mer om hur vi behandlar dina personuppgifter i vår integritetspolicy.


Our website uses cookies. By continuing to surf on the page, you agree to us using cookies. Click here for more information.

I understand